LM393 Detex audio class D amp

[NWS]

hi all.

i made this amp:

it work but have very low power.
and + rail mosfet get warmer.

i need your helps to solve these problems and power up it to 400w/4R.

 

[NWS]

is this sch better than upper sch?

i don't like to use irs2092 because i can't find original ic.2092 expensive.

i just like to make class d amp with 494 or 3525 or with op amp.

i tested 494 but mosfets get warmer about 50 60 degree.
if anyone have tested sch of class d amp with tl494 or sg3525,ir2153 or etc plaese send here to use or send here refrence address

 

[Khron]

I don't suppose you've ever looked up the original UCD whitepaper, have you?

https://assets.nexperia.com/documents/user-manual/UM10155.pdf

 

[NWS]

i didn't see. i don't need hifi quality because i use it for subwoofer.

and UCD 's board a little big. I have space restrictions
IC occupies less space.

What do you think of the circuits I've posted?

I love this schematic how is it:

As i don't get good result from TL494 ic for class d,I don't know about it works.
but someone has tested it and get good result.

see here:
DIY Good Class D amplifier

 

[Khron]

12x15cm is a little big?

What power level DO you need, by the way? And for what load impedance?

 

[NWS]

I said in the first message 400 watts on 4 ohm

 

[NWS]

İ have idea.
i can use a class d amp that have square wave on output(like the TPA series)
Then boost the output with external mosfet.
this have beter result but there is a little problem. i can't find tpa ics
it just on kits.

 

[Khron]

"Boost the output"? Not gonna happen.

Why not just go for one of the many IRS2092-based amps out there?

 

[NWS]

because i can't find original ic.
and ready kits are also expensive.

 

[Khron]

You're not trying hard enough then Mouser carries them, and so do Farnell and Digikey.

Ready-made amps seem to start for around 20$ on eBay. If that's still expensive, then i don't know what else to tell you

 

[NWS]

I am in Iran now and the order from abroad is not affordable

 

[Khron]

Those cheapest eBay amps are from China ("obviously"). Maybe searching for something on the local market (if at all possible) might be... better? I dunno...

 

[NWS]

that's true but i can't order from china or USA now .
i must use 494 or 3525 or etc for this project.
why U don't like 494 circuit?

 

[NWS]

i find a page about tl494 amps in site.
DIY Good Class D amplifier