Hello all,
I have changed all capacitor in my Parasound HCA-2200II but not the NP type that sits on the transistor board on the diagram it says NP 10V / 50 ?? but there is a 10uf 80V
My question what is best to replace it with?
the 2 x 47uf is replaced with Elna silmic II 47uf 100v
Regards
Soren
I have changed all capacitor in my Parasound HCA-2200II but not the NP type that sits on the transistor board on the diagram it says NP 10V / 50 ?? but there is a 10uf 80V
My question what is best to replace it with?
the 2 x 47uf is replaced with Elna silmic II 47uf 100v
Regards
Soren
Attachments
I doubt there is any other reason that voltage was chosen because they probably had a box full to use up.
There can never be more than a volt or two across it due to the junction voltage of the transistors Vbe.
I also doubt it is faulty but replace it with whatever you want.
ECEA1HN100U | Panasonic 10μF Electrolytic Capacitor 50V dc, Through Hole - ECEA1HN100U | RS Components
There can never be more than a volt or two across it due to the junction voltage of the transistors Vbe.
I also doubt it is faulty but replace it with whatever you want.
ECEA1HN100U | Panasonic 10μF Electrolytic Capacitor 50V dc, Through Hole - ECEA1HN100U | RS Components