PSU for Papst turntable motor

[markul3]

Hi
I bought an old Michell Gyro Dec turntable with Papst AC motor (produced in the 80s).
The set is lacking power supply.
Any hints where I can get an inexpensive (not necessarily Michell) power supply for the Papst motor? It states on the motor: "Papst MOtoren KG, 901 3520 001, HSZ, 20.35-4-232, EeM-B112, 24V, 50Hz, 22 µF, 2.-87
Thanks
Mark

 

[Kay Pirinha]

If you're living in the 50 Hz world, a 24 V 0.5 A transformer will do.
Best regards!

 

[analog_sa]

With a capacitor, presumably.

Or something more ambitious.

 

[Kay Pirinha]

Of course this Papst motor needs a run capacitor, see the writings on it. I guess it's a synchronous motor with a fixed field and the rotor spinning around at the outside?
Best regards!

 

[Ketje]

Look here, an topic about the aussenlaufer !
DIY 4 Phase Sinewave Generator for Turntable Motor Drive
Mona

 

[Kay Pirinha]

Yes, if the 4 phase generator is used, the run capacitor can be omitted. Just connect the motor to the 0 and 90 deg phases and make sure the LM3886's can provide 24Vrms each.


Best regards!

 

[markul3]

Thank you all for advice