I can put it in and if you don't need it, just jumper it. Does that sound good? Shurter OGN fuse holder looks nice, and you can put an isolation cap on it if you want.
http://www.schurterinc.com/pdf/usa/c_ogn.pdf
Measurements are:
Single: 78.74mm x 88.9mm
Dual: 139.7mm x 88.9mm
Tripe: 200.66mm x 88.9mm
That sounds good.
I accidentally have some of those fuse holder in my parts bin.
yep that shurter part is just right; excellent mate, I was hoping that you might still be able to drop it in. that was the idea, too to enable it to be simply left out of the circuit if desired by the use of a jumper. thanks for the transformer info,m there are literally thousands of PCB mounted trannies at digikey
Last edited:
I'm also in favor of adding a fuse holder... which one will you use, the 25mm or 22.5mm??? Want to add some to my Mouser order before I submit it![]()
Schurter order number is: OGN 0031.8201 and its 22.5mm grid.
any chance we could have a 20 x 5mm fuse spot? though either is fine by me. glad everyone likes the idea
The Schurter is a 5x20mm fuse holder.
Boards have now been ordered.
Whoo Hoo! Great news! I hope to get them before my Twisted Pear Buffalo II DAC and IVY III gets here. (They are slated to ship sometime around the middle of March.
Bill
Any updates?
/U.
Boards are here, will start shipping out next week.
Any further updates?
Expecting my Buffalo any day now....
The boards have started to ship out. I have not been able to do all at once, but they should all be shipped by Thursday.
The boards have started to ship out. I have not been able to do all at once, but they should all be shipped by Thursday.
Nice!
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Group Buys
- Amveco toroid boards