It looks like this btw
An externally hosted image should be here but it was not working when we last tested it.
Not going to work did you see the picture I posted that goes on the board it's 8 leads thanks for your help anyways
Sorry I thought we were talking the 7200 series in this thread
Was not following every page.
If you contact Mouser and give them the #'s off that device they will research a suitable Xref for it
Was not following every page.
If you contact Mouser and give them the #'s off that device they will research a suitable Xref for it
I have never heard of a transformer going faulty in one of these or any Sanyo, Philips or Sony unit. Look for a short circuit diode in the secondary. If a diode is S/C then the power supply will hit over current and shut down, trying again as the equilibrium builds again.
If you can't get it fixed, I will do it for you.
Just what I thought Mouser would do.. They do have the MR4010 listed but they require you to buy 350 of them at $1.93 each and it has a 12-14 week wait.
That's what they sent me in the quote.
the MR4010 is made by shindengen and they are junk. Anything made by those guys are garbage. Does Sony ring a bell? They used them and they all failed.
Most suppliers arnt going to carry that IC, you will have to look for a pin-compatible equiv or ebay the IC.
Most suppliers arnt going to carry that IC, you will have to look for a pin-compatible equiv or ebay the IC.
yes I already brought the MR41010 from ebay at $8 a IC
So I know nothing about the Sony but what's bad about the chip? btw I ended up getting another projector so I can see first hand what is bad with the board when I have a working one next to it.
- Status
- Not open for further replies.