• WARNING: Tube/Valve amplifiers use potentially LETHAL HIGH VOLTAGES.
    Building, troubleshooting and testing of these amplifiers should only be
    performed by someone who is thoroughly familiar with
    the safety precautions around high voltages.

How much should i derate a damper diode ?

Status
Not open for further replies.
I've been reading about 5v3a rectifier (1.4A peak current, 6.6A transient peak, 350ma dc), i would have loved to use 2 x damper diodes, but i have room only for one tube.



I ran psud simulation with 5v3a and it gives a B+ voltage at C2 around 470v. I wonder if would be enough for kt88?

In the simulation, steady peak current was ~1A, below the 1.4A limit. And transient peak, around 4.8A, below 6.6A limit.

I think i'm going to give it a try, and do the yellow sheet mod, add one UF5408 on each plate.
 
Status
Not open for further replies.