Hey guys,
I've just bought a couple of these capsules to make a DIY measurement micro.
I already have a Behringer umc204hd interface with 2x xlr 48v phantom power inputs.
Do I need to build something to connect the capsules to the interface?
Thanks!
I've just bought a couple of these capsules to make a DIY measurement micro.
I already have a Behringer umc204hd interface with 2x xlr 48v phantom power inputs.
Do I need to build something to connect the capsules to the interface?
Thanks!
They need a low-noise supply in the 4-10V range with a 4-10K series resistor. Batteries are a good choice. Current draw is 0.5mA max.
Ed
Ed
where did you get your wm61a´s, i thought these had been out of production for years? i have ten of these capsules myself, both linkwitz modified and un-modified, mostly i use the un-modified ones. all my capsules measures differently, some very close and some measures way of, i sure would like to have a calibrated mic as reference to check my capsules out, correct or not, for now i use those capsules who measures close as accurate and those that differs as less accurate
I have some WM-63T capsules with callbration curves. Anyone know how different they are to WM-61A ?
Cant find the datasheet anymore , it seems to have vanished from the web. The capsule is the same diameter but a bit longer than
the 61-a. The connections are the same with the tiny track to the case so its quite likely that the linkwitz mod could be implemented.
I'll give it a go,
the 61-a. The connections are the same with the tiny track to the case so its quite likely that the linkwitz mod could be implemented.
I'll give it a go,
I got them on AliExpress. I have two ecm8000 that I can use as reference. My objective is to create a multi mic source to make measurements averaged in real time in a car. There are a couple of solutions like this but are expensive as hell
i wish they where, but they are not, some years ago i bought ten of monacor mce-4001 in hope that they where as good as panasonics, they where not, these monacor capsules where trash
people keep saying these mics are "ruler flat", did they check or they just refering to a datasheet graph?
some wm60 i had all measured differently.
i bought 10 cheap 5mm dia mic caps recently, there is a wide spread in response, but one is flat till 11k and another till 15k
(black is ref flat response)
