Spooky and Hellraiser SMD 60W amps (Wolverine compatible IPS)

[Chrisr3521]

Its unfortunate there are no proper schematics just LTSpice screen captures, If you download the Infidel_V1.0-package.zip from post #1, there's a schematic jpg, change the transistor types to their smd equivalents:
BC550 to BC850C
BC560 to BC860C
KSA992 to FJV992F
KSC1845 to FJV1845F
Q10 - 2SA1419
Q11 - 2SC3649

Also read this post - https://www.diyaudio.com/community/...-wolverine-compatible-ips.398785/post-7470392

That's great thanks and good advice for most of the transistors on the board it has three places for dual Ic's I take it I will be OK to take cues from the Spooky bom to populate these?

 

[Indiglo]

You should be fine using the spooky BOM, the transistors between the various boards are essentially the same, only the topology being different.
With no proper schematics and BOM can make it difficult for someone to gather enough information to populate the board.

 

[jwilhelm]

It looks like Q6/Q7 footprint is odd. Normally dual transistors have the bases on pin 2 and pin 5.