Hi Sommer,
Can't see the page ,could you post some photos may be?
Thanks alot.
yes, they are very different.
The red PCB is a pair of bridged channels and can only be used with 8ohm speakers.
The blue PCB is a pair of channels and can be used with 4ohm, or 6ohm, or 8ohm, or 4 to 8ohm speakers.
The Blue has UPC protection chip.
The blue has opamp input !
The red PCB is a pair of bridged channels and can only be used with 8ohm speakers.
The blue PCB is a pair of channels and can be used with 4ohm, or 6ohm, or 8ohm, or 4 to 8ohm speakers.
The Blue has UPC protection chip.
The blue has opamp input !
Why does the chipamp need an opamp to act as a buffer?
Because it's cool !
There are some equipped with a tube buffer .
I've read that the LM3886 does perform good with a 10/20 K pot at its input .
Not the same as for the LM3875 .
Of course I would bypass the IC buffer stage in that kit .
And I would start with a separate PSU for the tube one
I was ironic BTW
If you put something more in a kit ,I'm sure the goal is to 'catch pigeons' .
That buffer could be anything ...who knows...a DSP correction
and someone may think that a 'buffer' may be a plus . But it only guarantees a high impedance load to the device attached .
Reading the 3886 DS it is clear that it was projected to have an 'high acceptance' input ,thus not needing any buffer . Some people have reported that using vacuum tube for that duty is much better .
If you put something more in a kit ,I'm sure the goal is to 'catch pigeons' .
That buffer could be anything ...who knows...a DSP correction
and someone may think that a 'buffer' may be a plus . But it only guarantees a high impedance load to the device attached .
Reading the 3886 DS it is clear that it was projected to have an 'high acceptance' input ,thus not needing any buffer . Some people have reported that using vacuum tube for that duty is much better .
Wouldn't that be called a line driver?A buffer is usually there to drive the cable that feeds the receiver.
svsommer
I want to make a PCB for my TDA7293 IC pair so
help by Posting the poto of other side of the 2X PCB
Thanks !
try this design TDA7293V
Sorry I dond have any PCB designs as your requirement right now. If I can manage to get that, I will definitely post it for you.DEAR diptangshu !
THANKS BUT I WANT PCB WITH SPEAKER PROTECTOR.
I THINK THIS IS BEST PCB.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Chip Amps
- Maybe I should go for chip amp!