That’s what’s strange, I had been using a MUR1620 with a bad section (only one good diode) for testing and that worked. I just bent the leg for the bad diode out of the way, so it wasn’t connected. So I put a brand new one in and it fried. Not sure what to make of that. With a single diode it came online like a champ and I was actually able to null out the speaker terminals with the offset pot.
I picked up a few because I saw you recommended it in another post
JL 500/1 rectifier replacment?
How much voltage is enough, 400@16A?
JL 500/1 rectifier replacment?
How much voltage is enough, 400@16A?
I thought that I saw the 1606 as a 600v as well but the datasheet I have here says 400. Did you probe the input to the rectifier to see the actual swing of the transformer output?Remember that it has to withstand the entire peak -peak voltage.
I think that 400v was sufficient but you should confirm.
I think that 400v was sufficient but you should confirm.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- JL 500/1 (V1) Q507 no gate drive